DARINGRUN FLIP 6P Software Guide

• Wired Hotswap PCB support on VIAL software.No need any firmware.

          Download VIAL here:https://get.vial.today

• Tri-mode Hotswap PCB support on VIA software.

          Download VIA here : https://github.com/the-via/releases/releases or web page

          Download json firmware here

How to use for tri-mode hotswap pcb?

1. How to switch wired/2.4G/bluetooth mode?
2. How to recognize it in VIA?
3. How to switch win and mac layout?
4. How to restore defaults settings or no any responding?
5. How to turn on/off only the left side light or right side light?
6. How to check the remaining battery?
7. Why I can not use win key?
8. What is the default list of shortcuts?

1. How to switch wired/2.4G/bluetooth mode?

 Video reference:

Pls make sure that the battery switch on pcb should turn on (left to on) before you use it.

2.4g mode

①Code it first(make sure the pcb close to the 2.4g receiver when code first time):

long press(about 3 seconds) FN+R,there will be fast green flashing light,then plug in 2.G receiver, the green light will continuous 3 seconds and then off if code successfully.The green light will fast flashing light 30 seconds and then off if not code successfully.

②Switch to 2.4G mode: after code successfully,short press FN+R each time when you need to use 2.4g mode, the green light will slow flashing light and then continuous 3 seconds and off if it connects successfully. The green light will slow flashing light 1 minutes then off if not connect successfully.

Bluetooth mode

①Pair it first: long press(about 3 seconds) FN+Q/W/E,there will be fast blue flashing light, then use your cellphone/computer search and find the bluetooth device DR-6P-BT1/DR-6P-BT2/DR-6P-BT3 and connect. The blue light will continuous 3 seconds and then off if pair successfully. The blue light will fast flashing light 30 seconds and then off if not pair successfully.  

②Switch to bluetooth mode: after paired, short press FN+Q/W/E each time when you need to use bluetooth mode,the blue light will slow flashing light and then continuous 3 seconds and off if it connects successfully. The green light will slow flashing light 1 minutes then off if not connect successfully.

Note that long press FN+Q/W/E will clear the bluetooth pairing that previous connected, so after long press, it need to pair again.

Wired mode:

Short press FN+T,then switch to wired mode(the red light will flashing light 3 seconds),plug USB_C cable to use wired mode.

2.How to recognize it in VIA?(It can not recognize in VIA when on bluetooth mode, pls switch to  2.4g mode or wired mode)

①Recognize in VIA web page: https://usevia.app/，open VIA web page, and load the json file(do not click"use v2 definitions")

Choose and click to connect